EN ISO 15084:2018 Strong Points Compliance Checklist

1. GENERAL REQUIREMENTS (Clause 5)

Ref	Clause	Requirement	Status	Inspector Notes
1.1	5.1	Strong point may be used for different purposes (anchoring/towing/mooring)
1.2	5.2	All craft: one anchoring/towing point forward

2. STRENGTH REQUIREMENTS (Clause 6)

Ref	Clause	Requirement
2.1	6.2	Forward anchoring/towing: Pf = (4.3LC - 5.4) × f (kN)
2.2	6.2	Forward mooring: Pf = (3.5LC - 4.3) × f (kN)
2.3	6.2	Aft mooring: Pf = (3.0LC - 3.8) × f (kN)
2.4	6.2	Breaking strength not required higher than boat mass (mLDC)
2.5	6.3	Direct calculation method (if used) accounts for design category, windage, hull form
2.6	6.4	Strong point strength ≥125% of specified rope/chain breaking strength

3. DETAILED REQUIREMENTS (Clause 7)

Ref	Clause	Requirement
3.1	7.1	Craft structures reinforced to take calculated loads
3.2	7.1	Doubling plates or washers of adequate size used for bolted connections
3.3	7.2	Strong points made of corrosion resistant or protected materials
3.4	7.2	Non-metallic strong points are UV stabilized
3.5	7.2	Warning notice for non-metallic strong points in owner's manual
3.6	7.3	Strong points labeled where intended use not self-evident

4. OWNER'S MANUAL REQUIREMENTS (Clause 8 & Annex A)

Ref	Clause	Requirement
4.1	A.1	Breaking strength of strong points provided in manual
4.2	A.1	Caution: lines/chains should not exceed 80% of strong point breaking strength
4.3	A.2	Labeling and manual information for non-obvious strong point purposes
4.4	A.3	Caution: Always tow at slow speed, never exceed hull speed
4.5	A.4	Caution: Tow line must be releasable under load
4.6	A.5	Owner responsibility statement for adequate lines/chains/anchors
4.7	A.6	Non-metallic strong points: lifetime considerations and replacement criteria

Inspector

Name: ___________________________

Signature: _______________________

Date: ____________________________

Manufacturer

Name: ___________________________

Signature: _______________________

Date: ____________________________

EN ISO 15084:2018